Dunndeal
SparksMayFly
My system is 48 volt system. I’m using 16, 90 ah lifepo4
Cells. The voltage across my cells is 54.13 volts. The
voltage of the PV array is 164.1 volts. My “all in one” solar
charge controller is a Impinvt MPPT SCC 80 amp. My
inverter is a Flamezum 3000W/6000W pure sine inverter.
When I apply battery voltage and solar voltage to the
system I get a message on the “all in one“ that
there’s “Over voltage of battery warning. Again my
battery voltage is 55.20 volts. I get no voltage to the inverter.
Any ideas what I’m not doing. By the way, I disconnected the
victron BP because it will only handle 24 volts
Cells. The voltage across my cells is 54.13 volts. The
voltage of the PV array is 164.1 volts. My “all in one” solar
charge controller is a Impinvt MPPT SCC 80 amp. My
inverter is a Flamezum 3000W/6000W pure sine inverter.
When I apply battery voltage and solar voltage to the
system I get a message on the “all in one“ that
there’s “Over voltage of battery warning. Again my
battery voltage is 55.20 volts. I get no voltage to the inverter.
Any ideas what I’m not doing. By the way, I disconnected the
victron BP because it will only handle 24 volts