Lawrence_Hargraves
New Member
- Joined
- Jun 13, 2022
- Messages
- 2
Curious as to what ive done wrong here. Ive installed my second diy system recently and have had a low volatage fault. System is now disconnected until ive puzzled this out. Im also about 3 hours away from the equipment so ive forgotten some of the specifics.
The high level details are 2x Longi 370w panels set up in series, a renogy 60a mppt Charge controller and 3x 200ah AGM batteries in a parrallel set up.
Im using a 3000w renogy inverter. System was doing all that I expected for two days and the started getting a low voltage warning when high voltage appliances such as a toaster, a kettle or a microwave were used. These were all running well the first two days. Battery is showing 95% charge and 12.6 (or so?) V.
Hoping for some guidance as i feel as though ive missing something simple with the slightly increased complexity of the system. Use is larelgy for LED lighting, phone charging and running a small fridge but the kettle would be a nice convenience. Thanks in advancd for any help!
The high level details are 2x Longi 370w panels set up in series, a renogy 60a mppt Charge controller and 3x 200ah AGM batteries in a parrallel set up.
Im using a 3000w renogy inverter. System was doing all that I expected for two days and the started getting a low voltage warning when high voltage appliances such as a toaster, a kettle or a microwave were used. These were all running well the first two days. Battery is showing 95% charge and 12.6 (or so?) V.
Hoping for some guidance as i feel as though ive missing something simple with the slightly increased complexity of the system. Use is larelgy for LED lighting, phone charging and running a small fridge but the kettle would be a nice convenience. Thanks in advancd for any help!