GXMnow

The way the relays in the XW+ and XW-Pro appear to be the same. There is no setting to change how it controls the relays, other than...

I only have a single XW-Pro running as "Split Phase Master" but the idea is not that different. All of my neutrals tie back to my main...

Today was productive. The battery was fully charged before noon and the house was running totally off of the Enphase system. So I took...

I looked at the other thread. A while back I did the same math and figured it would not fail in a bad way, but the batteries from the 2...

Are you going to swap from the NMC cells to LFP? I could not find a voltage range to make them work well together.

Well, if I wasn't already sure, I'm now convinced, this is an addiction. I don't need it, but I picked up 48 used EVE cells from...

I got 2 pics from the outside which sort of show the way it sticks through. The inside pics didn't show anything. It comes with that...

Midea seems to make good stuff. I'll watch to see how your setup holds up. I also looked into the twin hose models, but ran into similar...

My original thought was to have the hot water line from the main water heater go to the inlet pipe on the electric one. They typically...

I have thought about that. Two of my bathrooms are at the far nd of the house from the 40 gallon gas water heater in the garage. I have...

I was out of town for work for nearly a full week. I was only a little closer to the Eclipse though. It was still only about 50% cover...

Here is my production graph from So Cal. Well out of the total coverage area. The power cut to about 50% on a totally cloud free sky.

Production is basically done for the day. It looks like I pushed about 2 KWHs from the DC system out to the grid. That made just enough...

We had 2 days of poor production, and my battery got down to 51 volts, I have it stop grid support at 50.5, so it was about as low as I...

PV solar power does not really work like that. The amount of power coming from the panels is constantly changing with the amount of...

I just found these on Amazon. They would probably be great for what we do under 100 volts...

Mine are over 20 years old. They are below the "Class 0" electricians gloves. Mine are probably rated to just 500 volts, but thy bend...

Here is the line I used for my DC breakers...

Not always. It is very possible for the inrush to fry the MOS FETs. And in many cases, when they fail, they can fail in a short...

Many of the "Server Rack" style battery units do have a pre charge circuit. If your battery has it, it will be clearly mentioned in the...