iSwannie

Hi Lithium Cowboy, Are you using the CAN or RS485 to communicate from EG4 Hub to Cerbo?

Hello Parody, how do you configure things to be able to view dashboards on local system so you can view them remotely? iswannie

At first the L1 fan noise was loud. I upgraded the firmware and it seemed to go away. However, I have not been putting much load on...

I have upgraded from 2 Multiplus II 48v/5000kva inverters to 4 inverters in 120v split phase. L1 has a Master and a Slave so does L2...

Hello, Has anyone tried to add closed loop communications to the Kong Elite batteries?

Archerite, this looks to be a good direction you are going. Any further updates you can share? Steps of the process to get to where...

That setup sounds awesome Madcodger! I agree, the new EG4 inverters are appealing, but I decided since this was about my 4th inverter...

The two EG4 6500ex were up-to-date on firmware. However, we experienced flickering lights daily and my UPSs I have staged around the...

No more room to the right side. My batteries are usually charged before 2 to 3 pm as long as we have good sun, so shouldn't need more...

The EG4s were doing a decent job. In example last July my solar system produced 2 megawatts with the EG4 6500ex inverters, which was...

Adam, I would not be where I am with a Victron system if it were not for your videos and help! Thank you!

Hello, I just swapped my off-grid EG4 6500ex inverters over to two Victron Multiplus II 48v/5000kva inverters with a 450v/200A Solar...

Hello Solar Fans, WATTs up :)! Does anyone have experience with configuring successful communications between Multiplus 5kva 48v...

Have to calculate for the record cold temps the area you are at. Also need to do the math for increased production. Not just what you...