-
-
Rednecktek reacted to keepinpalid's post in the thread Fuse use in the mobile 3000w system with
Like.
Thank you rednecktek. So if my batteries also have breakers on them then I should be ok with just one fuse between the batteries and the... -
@Rednecktek Nah, the tubes are easy to find. 12V LED T8 bulb Actually, I just found my answer in that listing! It is pretty straight...
-
Rednecktek replied to the thread 12V Fluorescent Light changeout.Assuming you can find 12v tubes that fit in there, you'll have to figure out the polarity and just wire the leads to the appropriate...
-
Rednecktek replied to the thread Fuse use in the mobile 3000w system.Optimumly... 100a fuse from the batteries to the inverter, fuse/breaker between batteries and 12v converter, breaker between solar...
-
Rednecktek reacted to yodamota's post in the thread Possible to use new MC4 panels with old inverter. with Like.
yep, it will work.
-
Rednecktek replied to the thread Scored a heap of lead acids next port of call..How much wattage you looking to get? Most of the players out there have lots of 240v units and offer a couple 120v versions for them...
-
Rednecktek replied to the thread Scored a heap of lead acids next port of call..Aaahhh, that's what I was wondering.
-
Rednecktek reacted to wpns's post in the thread Scored a heap of lead acids next port of call. with Like.
Umm, yes? Grid tied with no battery, that's how it's supposed to work...
-
Rednecktek replied to the thread Scored a heap of lead acids next port of call..Sssooo... if inverting is the process of turning DC into AC, and your inverters have no battery connection, then what are they using for...
-
Rednecktek replied to the thread Cut that high speed cable!.My camp there are the options of Starlink, Starlink, or Nuthin. I don't get OTA TV or FM up there, you can forget about any kind of...
-
Rednecktek replied to the thread Scored a heap of lead acids next port of call..What kind of inverter do you have that won't run off batteries? AGM, Flooded or Sealed lead acid? If they're Flooded or (some)...
-
Rednecktek reacted to wpns's post in the thread Scored a heap of lead acids next port of call. with Like.
Lead acid doesn’t need BMS
-
Rednecktek replied to the thread Top Balance question.Perfectly normal. You're not getting 20a of charging, you're getting 20 / 16 = 1.25a at best per cell, so honkin huge cells at 1a are...
-
My logic with 2 bus bars is that it's like a thicker wire. If I only use a single busbar, there's a lot less cross-sectional area of...
-
Rednecktek replied to the thread 24 volt solar fridge questions.The wiring is easy, just run from your bus block on the battefies to a fuse to the fridge. As for power consumption, anything that runs...
-
Rednecktek replied to the thread Will Solar charge controller work..Only the blue ones, which is one of the reasons I won't buy them. There are many brands out there that work just fine and don't cost the...
-
The only winners will be installers gobbling up that sweet sweet .gov money
-
I’d just toss it in a generic cheap plastic group 31 battery box you can get at Walmart, Napa. What BMS are you going with for your...
-
@BradCagle has used Sun fun kits and liciti to put raw cells and BMS in a box.
-
Also set the SCC to float 8*3.45v and let it bake. If you’re not in a rush let the BMS do its job.
-
-
Loading…
-
Loading…
-
Loading…
-
Loading…