Recent content by Acho_303

Today after messing with my clutch fan for a bit I came to the realization I needed a special tool... So the altenator isn't installed. I did take out my 544ah of lishens and installed the new 1240ah eve bank. It's currently charging from my multiplus which is plugged into my generac... only 6...

How do all these setting look? When I first check the max cell voltage was set to 3.85...

It is odd, when I use my voltage meter I get all the cells at 3.33, but recs wifi shows the following

Started wiring, my 4/0wire is at my bus so I'll need to make those cables tomorrow. My plan is to get the battery hooked up, install the altenator, then wire in the wakespeed

@upnorthandpersonal @HRTKD Can you guys advise to the best placement on the image above for my bms wires

Pulling it all together I cut my allthread to length and filed the tips so bolts could go on, cut the cutting boards to size, and sandwich everything

I glancing at my transition I think about taking a few pieces of angle to build the box out of metal... but metal and electric never sits right with me

Oiled

Drilled, and sanding begins

Basically here I am just marking between the cells for drilling

Next step back to the batteries to get more measurements, this time with my wood carcasses

I cut everything about a .25 too long to true up everything by bringing it in after establishing straight lines on the saw

Found a piece of scrap wood, 1/2 baltic birch that I'll use for this project

Need to repurpose my ski tuning/waxing station back into a saw