Most reacted threads

Hello, I'm starting this thread due to seeing a lot of new information for the eg4 6500, but not so much for the 6000ex. Specifically for the new FW updates concerning led flickering fixes. I managed to successfully update the Main CPU and it is showing 63.11 version on the inverter. My...

Hello, I just went through the new upgrade program to exchange my 6000ex to a new 6000xp. FYI, came to find out later on that the shipping for people on board with this program starts in May 15th. I appreciate the program, but this delay certainly pushes back my project and was informed...

Hello, If you have a Raspberry PI from SA already activated and connected to your "site" here is what I did. So, I wanted to share how to get SA working with the EG4 6000ex as when I was trying to configure it out I saw little to no information on it. Hope this helps somebody in the...

Hello, what happened to all the available settings that you could access through the EG4 monitor app (android)? Qent to make some changes and found out the majority of the settings were removed.

Hello, I boughta EG4 3000 EHV with an EG4 LL v4 battery. Mainly used for my mothers house in case of a power outage. I have another setup with 6000xps and also use Solar Asistant to monitor. All is conected and working fine. Except today I received my NEW SA to monitor my mother's setup (eg4...

Hello, I installed an EG4 3000EHV inverter with an Eg4 LLV4 100 AMP battery, The system has been working in closed loop for some time. I've noticed that once its fully charged at around 56.2v.......it will float around 56v. Is this normal for this system? I have two 6000xps and they float...

Hello, So I received my brand new 6000xp and connected it to my 5 LLs. All the batteries were fully charged as they were constantly used for about two years until a week and a half ago when I decided to upgrade from a Eg4 6000ex to an Eg4 6000xp. When I use close loop, the state of charge...

My inverters (2 6000XPs in parallel) are running perfectly on 190D0E for more than a year. Wondering about new features / or improvements (if any) of making this FW upgrade.

Hello, Currently building a new system with as EG4 6000EX. I will be using grid pass-through to power the house when no batteries are available and solar is not enough. My current panel which will feed the pass-through input has a N/G bond already. My understanding is I need to remove the N/G...

Hello all, I just bought an EG4 6000XP to substitute a 6000EX that went bad. Trying to get the correct size for the knockouts for all the connections to buy the cable glands. I know that there was another post with a picture of the sizes but apparently EG4 have changed them since then...

Hello, I have two 6000xps working in parallel with 31kw on EG4 LLs. Currently working without issues. Looking at the EG4 monitoring site I see a new update is being suggested. I'm currently on ccaa-180C0D The EG4 site firmware change logs do not show what improvements are included in this new...

Good morning, my sistem has been in working order for about 30 days. Besides some trouble at first with comunications between my EG4 LLS all has been flawless. Since yesterday system started to shut down and throw Fault 22. First time it happened it restarted itself again and everything went...