We have battery monitoring on each site and we get snapshots of the sites every 30 seconds.
When the sites reboot, the parameters on the sites are usually like this:
Battery Voltage: 27.3V
Charging: 1.2A
Load: 1.6A
Temperature: 23.5C
We are using the 100A Daly Smart BMSes and we have Bluetooth...
The batteries are basically new. Less than a month old.
We have one site that we tested now without a solar charge controller (we hooked up the system and did not connect a solar panel to the site). It has been running for 2 days without any rebooting and sits now on 50% capacity.
Good day.
Yes, it happens close to Dusk, only.
We have 8 sites running on the exact same setup. 6 of them do it. One of the sites always powercycles late in the afternoon, around an hour before dusk.
We ran the sites on PWM and Lead-Acid systems before without any issues. The rebooting only...
Good day.
I have a Daly BMS on a 24V 202Ah LiFePo4 battery system. I am using a Victron 100/20 MPPT Solar Charger. Currently, the equipment and Charge Controller's Negative wires are connected straight to the Daly's "P-" Black cable and the Equipment and Charge Controller's Positive (Red) wires...
Good day all.
I am new to DIY Solar Power Forum and I do hope that I am asking this question in the correct Forum.
We have a couple of Wireless Internet Towers and we have recently changed over from using PWM Solar Chargers with Deep Cycle Batteries to MPPT Solar Charge Controllers with 24V...