Recent content by Buffalo

Thanks

It's a above ground shallow well pump, I'll check the specs

Can I run my 240 volt 3/4 hp water well pump with 2 Growatt 3000tl lvm Wired in split phase 120/ 240 volt

Thanks men, I just don't want to burn up good equipment.

Should I just parallel the battery's and leave aray hooked up to one invertor to charge batteries .

Thanks for you help, I will have to dig a little deeper.

I have 24 volts of 271 ah now and am getting a eg4 200 ah and another invertor. Want to hook new battery to new invertor and keep diy battery on old invertor. The invertors are both growatt. Thank you for any help.

Tried search, can I wire my solar array to two Invertors. I am installing a second invertor for split phase.

I have one cell not working properly in an 8 cell pack. I would like to replace it. Doesn't need to be an exact match. Iet me know what you got. Thanks

You may want to wire your panels 2p3s, I have the 3000tl lvm and it can only use 145voc max. You may want to check your manual.

Found the problem. I only had bms wires connected, and did not have the main negative wires connected, hooked them up and all is good. I was just going to use bms to monitor battery will top balancing learned something new.

Found that post they are using ios app and I'm on android and it is configured differently and does not have that settings. Thank you for the help, I couldn't do this without everyone's help

Just hooked up my bms and it is not giving me correct voltages, here is a screenshot of dashboard. Thoughts on what maybe wrong. I checked voltages in the connector before hooking it to the bms and it read all voltages through the leads.

Thanks for your input, I am using my system to run a few appliances in my shop and as backup power for outages. I am just wanting to know about the float setting as I have read that lithium batteries don't need this .I think I will use user 2 setting and set 19 and 20 to 27.8 and try that for a...

Anyone