diy solar

diy solar

Recent content by burgerking

  1. B

    Deye 5k Hybrid zero export to ct issue

    I am sure this is not how to use Twisted Pair cables. You should use only 1 pair, and use Pure Copper (not Copper Coated Aluminum) as it needs to conduct as much as 1A. Better result is to use Shielded Twisted Pair: each pair is shielded Best result is to use Double Shielded Twisted Pair...
  2. B

    re 3Phase Electrical System: Y and High Leg together

    I visited my brother in law in the big city (Manila); he lives in a mix Industrial, Commercial and Residential neighborhood were 3Phase Y or Delta (3 Transformers) coexists with 3Phase High Leg (2 Transformers). I traced the posts and wires and both groups of transformers share the same High...
  3. B

    What BMS uses inductive balancing?

    Me too. And not just Balancers, but also the BMS. Inverters are getting higher and higher power, HV batteries (>90v) are gaining traction.
  4. B

    High voltage BMS suggestion

    That is prohibitively expensive! Almost at cost of commercial HV battery packs!
  5. B

    JK B5A25S60P BMS

    On your photo, are you trying to make a high voltage battery pack using small BMS in series?
  6. B

    High voltage BMS suggestion

    1S bms that can be strung together for form higher voltage.
  7. B

    Yet another erratic SOC readout case of JK BMS :-(

    I have long abandoned SOC as well. Simply put, you cannot count electrons and expect all electrons are accounted for. Just imagine: if your BMS has an accuracy of 99.99% or 0.01% error. In 1 hour time it has accumulated 0.01% error; in 24 hours 0.24% error. How much error do you think it...
  8. B

    Does JK BMS log Cell Under Voltage Protection (Cell UVP)?

    There is timer when it reaches Undervoltage? Where is this variable? Attached are my current settings and system logs. I changed my over temperature to 40 yesterday; will bring it down to 39C once I fix the cooling.
  9. B

    Does JK BMS log Cell Under Voltage Protection (Cell UVP)?

    oh.. didnot know. i was out of the loop for a few months..
  10. B

    Q: MPPT

    Deye has logic built in circuit/logic to limit the power draw out of their MPPT.
  11. B

    Does JK BMS log Cell Under Voltage Protection (Cell UVP)?

    This Morning, my Deye shutdown (due to low battery) and I went to investigate the cause. My Deye is configured with Shutdown Voltage of 49.5V or an average cell voltage of 3.010V. My 16s JK is configured UVP of 2.800V and far lower than the 3.01V. However, it is possible one of the cells went...
  12. B

    Discharge rate?

    2 x 28kw water heater . . . you will need at x3 solar panel, x5 in battery storage this is a big system ... cost a fortune
  13. B

    Seplos goes dark

    Seplos Alibaba store?
Back
Top