Chaucer

I have a small teardrop with a 8735P converter. I'm almost sure the wire coming out from it is only 10 AWG..but I'll double check...

@Pappion I did what you say...but I have a 30 amp charger tied into the positive bus bar (not shown on my drawing). It blew the...

Yes. I would use at least 8awg, preferred 6awg, since your connecting to converter and fuse box. Odd that it is only a 30A converter...

@Pappion Good points. So I would tie in the 10AWG wire (to the bus bar) on the output side of the Class T, but before the inverter...

That's a good thought about keeping a LA battery for the brakes. When I moved my batteries inside when I went with lithium. One...

I was keeping the 30 amp circuit seperate from the higher load inverter circuit. If I move it to the other side of the Class T do I...

tks...I'm a bit fuzzy what you mean by "Green should be moved" You mean replace all the blade type fuses?

Hi, I was able to check voltage drops. Do these numbers make sense? This was before doing any changes or inspection of the connection...

Hi, This is the busbar. 400 amp solid copper https://www.amazon.com/gp/product/B08JKZ4GCN/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1

It's easier to spot when the loads are the highest. Anytime I complete a system, make any changes to a system or as part of an annual...

Hi, When checking voltage drop is it better to have a larger load like the a microwave or will a smaller load work. Asking because...

Voltage but I think you've got it!

Got..it may take me a few days..I'm going camping solo next weekend and will have time to check all connectons. The voltage drop just...

Ca Can you please provide me the technique to check voltagre drop so I do it correctly.

The fuse is 225A. I will check all the connections and confirm no washer under the lugs.

12V; Batteriesi parallel

All the large 2/0 wire are single lug per stud. I can take pictures, but what is recommendedso I can first check. Is it ...

Hi, A picture of my wiring layout? The warmest areas are the yellow circle and between the Class T and switch. Thank you

Hi , I recently installed 2 x 100 Lithium battery's and an 2000 inverter. I used 2/0 AWG wiring. While running the 900W microwave, I...

Sounds like it's faulty. Confirm it's for the correct input? 120 or 230V?