ChrisG's latest activity

Getting ready to do this work and rethinking use of gutter. Neutrals are also current carrying conductors. Moving 10 circuited will be...

I can’t search or see my previously posted content to get to a specific thread. I just get these errors. Tried both on and off WiFi.

I'm just moving my existing breakers to a matching panel, not upgrading to AFCI anything. Shhh..... No permits pulled here :sneaky:

Thanks @HighTechLab . This house is 25 years old and panel never touched so by extending to sub, now need to look across all circuits...

Sounds good. On the gutter 30 conductor part, this is in one cross-section. So, in other words, if you had 20 circuits in the middle =...

I plan on extending hot and neutrals for each circuit. Leverage busbar like Dexter did for ground. Reading further about derating: If...

@HighTechLab Do you happen to have the NEC code reference for this. I'll probably have 10 runs of 12/2 swinging over as well as the...

This is another reason why I prefer my panels accessible in an unfinished part of the basement and not in a finished wall. I can...

@HighTechLab, looks like you just had a ground bar in the trough for all the Romex runs and a single run down to panel. Inspector did't...

That could work. Note that code limits you to 1 3/8" holes in load bearing studs, so you will be limited to about 1 1/4" EMT conduit types.

Just watched a video from @HighTechLab. He did something similar to extend his romex during his home Solark install. Looks like he...

Nope. Here they are after I took that blank plate off. No wiggle room at all. Counted 17 romex coming up center large knockout on panel...

The 10 circuits I want to move to CL Panel have about 5” of romex jacket on them between bottom of panel and bottom wall plate(red line)...

Think I’m going to just drill another hole through the stud and have two nipples between the panels. This TS one looks to be 1” and I...

@billvon So I can splice romex to romex in a 6”x6”x36” wireway/trough going under the panels and terminate in sub panel. I bet I have...

@billvon So for #1, I can splice romex to romex in the wireway and bring it to second panel. If so this is great, have about 100 feet of...

Been skating by with a full main panel and manual transfer switch for inverter for a while now. Well we bought a PHEV and now need to...

Not at my cabin right now but believe it is 99%

My charge voltage is 55.6v but SOC is hitting 100% before that so balancing doesn’t occur (luckily my pack is balanced to .005v).

Thanks @sijones2010. I’m sticking with the non-testing branch. It has worked well for over a month for me. @ScrotusGobbleBottom and I...