Recent content by Emtmark

I’m trying that now but I’d like to interrogate them via the bms but I haven’t found anyone that has figured out how to connect to the mother ship on the rt series

This gives me hope I just got four all listed as pulled from working and tested. None were above 3 volts :( I’ll try to wake them up tonight ty for procedure

so i resolved the capacity issue but still would like to talk to my RT's any progress on any front?

did you get any software to work with your RT batteries?

Battery number three

June 2016?

First battery second battery Flashing green led !!!!!8.6volts!!!!! Was 13.6 when I started test on batt one And tested the same when in the trailer I think we found the turd

Update I ran the whole three batteries down and only got 79 amp hours out of it. So I pulled them out of the trailer charged them all up and am testing each battery separately. Not using alligator clips, AND using the four wire config on the DL48 so the testing unit has a reference voltage...

Bringing this back I also have a few RT I would like to examine more closely Disappointing to think I won’t be able to, ordered the cable already and was looking forward to interrogating the battery bms for clues My three only seem to come up with 60aH between them and I’m trying to figure out why

Huh? I moved the board to see the numbers better and an alligator clip launched into orbit?! Thanks for your input

And now I’m pissed because a lead slipped off and I have to start over ?

I ordered a capacity testing kit, so far it’s counted roughly 60 amp hours out using a 10 amp load Double picture was my fault I deleted the second one I set the cut off at 11v

Just noticed two batteries are the U1-12RT and one is the RJ I don’t know if that makes a difference? Also this is happening

Ok voltage on each battery was 13.6 with no amp movement being detected by the AiLi shunt