Most reacted posts

I won’t have my Insight Home connected until my longer cat 5e cables come in. I don’t think I’ll be able to set up the closed loop communication until I order the right cables to update the EG4 firmware (which will be months from now).

I'm unable to power up my XWPro, but I was able to connect to the MPPT 100/600 (network termination + Xanbus) and get it to charge my batteries today.

And... it was a false start. I tried to turn on the XW Pro today after warming up the shed, and nothing. Once I had the MPPT Charge Controller enable, flipping on the breaker shows a quick flash of the display, but then nothing. I'm thinking it's a startup sequence / timing / surge issue (as...

Quick update: I heated the electrical shed another 10F degrees, and the system powered on. It was about 25-30F when I first tried this morning.

It's right at the XW's terminals. Every once in a while, when I flip the breaker, it will flash something illegible, but nothing permanent.

I even tried connecting up 120V from a generator, but no luck.

An InsightHome.

No fault code on the battery unless it’s too cold (happens in the early morning). Working on insulation and warmer for them. I’ve tried the steps in the following orders, but no luck: Battery on/off Pre-charge resistor* Battery Breaker @ XW BMS Pre-charge resistor* Battery Breaker @ XW...

Summary: I was able to get the Conext XW Pro to boot up and invert on first try. Today, it won’t turn on under similar conditions. The long story: I purchased the complete hybrid kit from Signature Solar and spent a ton of time trying to make sure things are wired correctly. First try turned...

The EG4-LL's should have a pre-charge resistor. (I followed their process on YouTube without luck.) In the middle of nowhere, so also tried with a pencil + cables.

Does not work as in not charging the batteries or not communicating on the Xanbus? My Cat 5e cables don’t come in until next week, and I’m an hour away from stores.