Recent content by GuardianZX9

The first set I printed I used ASA(UV resistant) I plan to print a few more copies with HIPS, ABS and PLA just to see how they hold up over time. I did not paint, I used white ASA filament.

Original is on PinShape https://pinshape.com/items/22775-3d-printed-solar-panel-bracket-for-rv-roof Alternate versions on Thingiverse https://www.thingiverse.com/thing:1012036 https://www.thingiverse.com/thing:2432700

I will see what I can do. FYI, these are printed in ASA as a test, I have another set printed with HIPS and ABS just to see how they hold up over time. ABS would be the cheapest, and no need for high infill or expensive filament, they are VERY thick, just use 3-5 perimeter shells for extra...

I am using these, 3D printed, super strong, very lightweight and cheap to print if you are able. No screws through the roof, silicone mounted, 2 screws for each corner, there are also center mounts I have not installed yet. I have the STL's if there is any interest.

Following, collecting parts and information. I will be installing in a 2015 Redwood 38RL. Attempting to fit 3KW solar on the ample rooftop. Have 16S 320ah 3.2v LiFePO4 cells to start Looks like all Victron for me, everything just seems to play well together and they have some nice all in one...

Love it! getting ready to convert my 42" Redwood to an offgrid capable system, amassing all the components and still learning. I think I will go the 24V route as I was able to find a Victron 70 amp 24-12 converter and I don't have much of a 12v load. Did you move your battery bank into the...