HRTKD's latest activity

Just a thought, but wouldn't a steel "board" make the wire runs easier for equipment that needs a ground? 2" of wire to ground it.

Only in that it's conductive. If it's thin, then it may not have much holding ability.

I'm using the Hardie Backer Board for the underside of the lid on my component/battery compartment. The top of the lid is Luan, a bit...

What's the best gift to give?

LOL! I get it.

I have two of the digital torque wrenches. I defaulted to another digital, but it's not necessary. I suspect that at 450 lb/ft, being...

Ugh, I wish I hadn't looked. $1430 and it's 3/4" drive, which means I would have to add another set of sockets or use an adapter...

Normally, I would agree with you. My brother is a Snap-On dealer, so I get a decent discount. But I just don't want to spend the money...

Death Wobble was a new term to me when I bought my F-350. I've had it three times since 2017. The first time was my fault. I didn't...

Those of us with solid front axles understand this. Instead of a speed range, my warning would be more like, "Don't hit that damn...

I'm sure it was made with Rising Flour.

Not as good as the Star Trek meme...

Definitely put the hardi backer over plywood, the hardi backer itself has no holding power on it's own.

I have not shopped for retail cable that comes with lugs. My only concern with buying cables from someone else is that you have to...

No, both the shore power and generator are inputs to the transfer switch. This is typical of most factory installs where the RV has...

The forum software munged the diagram and reformatted it into making no sense. Here's an image of what my diagram should look like.

Most of the LiFePO4 batteries with internal heating will not provide heat unless there is an external charge. The BMS does not draw...

Just for clarification, I'm not sure that the original question of how to route the AC circuits has been answered. I've done two...