Recent content by iSwannie

Hi Lithium Cowboy, Are you using the CAN or RS485 to communicate from EG4 Hub to Cerbo?

Hello Parody, how do you configure things to be able to view dashboards on local system so you can view them remotely? iswannie

At first the L1 fan noise was loud. I upgraded the firmware and it seemed to go away. However, I have not been putting much load on the system. I plan to load it up within next couple weeks. More to come on fan noise.

I have upgraded from 2 Multiplus II 48v/5000kva inverters to 4 inverters in 120v split phase. L1 has a Master and a Slave so does L2 have a Master and a Slave. I also installed a Micro-Air ASY-368-X72-Blue on my 5 Ton Trane 2 stage heat pump. Nameplate LRA is 152.9, which is what I was...

Hello, Has anyone tried to add closed loop communications to the Kong Elite batteries?

Archerite, this looks to be a good direction you are going. Any further updates you can share? Steps of the process to get to where you are today?

That setup sounds awesome Madcodger! I agree, the new EG4 inverters are appealing, but I decided since this was about my 4th inverter swap out I would go with the Cadillac this time.

The two EG4 6500ex were up-to-date on firmware. However, we experienced flickering lights daily and my UPSs I have staged around the house for internet, cameras and computers would beep throughout the day. I also experienced the EG4 inverters to just shutdown around 5 times over the duration I...

No more room to the right side. My batteries are usually charged before 2 to 3 pm as long as we have good sun, so shouldn't need more solar added.

The EG4s were doing a decent job. In example last July my solar system produced 2 megawatts with the EG4 6500ex inverters, which was outstanding. They just were not very dependable and I couldn't leave the house knowing there was not remote capability to help my wife it something happened to...

Adam, I would not be where I am with a Victron system if it were not for your videos and help! Thank you!

Hello, I just swapped my off-grid EG4 6500ex inverters over to two Victron Multiplus II 48v/5000kva inverters with a 450v/200A Solar Charger while utilizing 900ah of EG4 LifePower4 batteries with an EG4 Hub and two 300ah Big Battery Kong Elite batteries. I currently have 4 arrays (11.5kw)...

Hello Solar Fans, WATTs up :)! Does anyone have experience with configuring successful communications between Multiplus 5kva 48v inverters with Cerbo to EG4 Communication Hub with EG4 LifePower4 batteries? Any lessons learned you can share? (i.e EG4 firmware upgrades, DIP switch settings...