Recent content by jkmastro

Yes. That is correct. L1 L2 a N and a ground. So would L1 and L2 run into the L on the transfer switch? Or is that not possible?

Ok, I will check on the mini split. But was also asking because I was thinking of just running my entire office through the transfer switch. For example: 50 AMP breaker runs from my main circuit box to a sub panel in my office. I was thinking to disconnect the wires from the 50 AMP breaker...

Thank you. Yes, split phase. Just doesn’t look like there is a place for a 3rd wire. My 240 volt mini split has two hots and a neutral. Any thoughts? Would both hots go in the single port?

Hello, Does anyone know if this unit supports 240 volt 2 phase? MOES Dual Power Controller 50A 5500 Watt Automatic Transfer Switch for Off Grid Solar Wind System ATS DC 12V 24V 48V AC 110V 220V. If not, any suggestions an an alternative? I want to power my office but the mini-split is 240...