Recent content by Kalinkoland

Hi guys, I have purchased some rack batteries. They claimed that it is with LiFePO4 cells. However I have looked closely into the test report and found that they used some odd looking pouch cell. 3.2v 50ah (see attached photo) I have seen that it is possible to get LiFePO4 cells in pouches...

Hi there, I need a BMS I can program for my cells. 3.2V 100Ah. 1C for infinity 2C for 120 seconds 3C for 60 seconds. I need to find a BMS I can program or is pre-programmed in order to pull 300amp of load from the battery for 60 seconds. Anybody has a good suggestion for this? Thanks :)

Hi there, A newbie question. If I have two 12V 100ah build with a 100a BMS each. I connect these two in parallel. Can I then pull 200 amp of load from it? The cells are rated 1C max continues discharge. Thanks :)

I live in Denmark Europe. Where do you live? Is it also a Chinese BMS?

Thank you all, for the fast reply. Balance wires are all the same length and cells match on voltage on the BMS. Shall I try to swap out the BMS? Or is there anything I can try to do first?

Hi Diy solar forum, I have made a 16s 48V 100ah battery with a DALY 100a BMS. All cells are balanced and working, but when I use them, at some point cell 15 and 16 start to drift off quite badly. I have swapped the cells two times and it is not a problem with the cells. The cells I have used...