I have ordered Samlex inverter today. I called before ordering to make sure they have it in stock and the unit is brand new. After reading this I hope I will receive it. Will post back once it arrives.
Yes I agree as well, I do not want to wait for hot water forever. I will go with 2000w inverter, still leaning towards Renogy thanks to the form factor and definitely 1800w induction cooktop. The guy in video is using NuWave induction cooktop that few people on Ford Transit forum use even with...
Thank you for your replay, what induction cooktop do you have? I wanted to get one from IKEA TILLREDA however few people state that it has parasitic draw of 100 - 150w when it is not ON.
Thank you all for your imputs. I guess I will go with 2000w. Victron Multiplus is nice unite but it is just too big. I guess I am going to try Renogy 2000w, unless you guys think there is better option in small form factor.
Thanks
Hi,
I am thinking about getting Victron Phoenix Inverter 12V 1200VA 120v for my small camper to provide power for single burner induction cook top and occasionally charging power tools batteries.
Do you guys think I can get away with 1200w or should I get 2000w. My components are all Victron...
Thank you. I checked all connection and it is tight and all was cleaned with rubbing alcohol. I connected my battery to victron MPPT and was closely watching what is going. Attaching screen shots. It looks like all cells are very well balanced until 300.5Ah once it got to 302ah in went all over...
I have my charger set to 14V and 30A…also I have 5A active balancer therefore I thought it will be able to keep up with my charger. What would you recommend to change the charger setting to? Thank you
I have just tried to charge my battery with Victron IP22 charger and everything went well until I hit 91%, my bms is showing alarm “cell over voltage protection” cell vent out of balance. BMS is showing 100% but victron shut is showing 91%. Prior hitting 91% shut and bms were showing similar...
Attaching few pictures of my battery in stainless steel group 27 battery box.The BMS as well as Victron BMV-712 smart battery monitor is attached to the lid of the box. My goal was to make the whole system removable therefore I am using Anderson powerpole connectors.
I have finally build my battery (See photos). Thank you all for your help! As I mentioned above I have JBD 250a bms with active balancer and discharge switch. Can you please check my BMS settings? This battery will be charged by Victron smart solar charge controller 100/30 and Victron blue...
Hi
I got JBD bms that has the option to install discharge disable switch. Do you guys know where to get one? So far I found only one for JK bms.
It should look like this.
Thank you