Recent content by Man

I agree. This was only for test purposes and your explanation seems correct.

Any idea how to turn off the red bar light on the MPP Solar LV6548? I did not see anything in the manual about it. There is no fault code, but I think it happened after losing grid power.

I'm going to spray them off and reposition them a little better then see how they do tomorrow.

Not sure if I would want to run Utility First? I would prefer it to use solar first for an RV scenario. Looks nice but Watchpower and the panel have been ok so far.

I learned a few things after some troubleshooting: I’m just not getting the wattage I expected from the solar array. I don't think it's the inverter. The max I have seen is less than half the 1500W. Is there a calculator somewhere to estimate what output to expect from the panels in full...

That's unfortunate to hear. I would have to get all new panels since I was going to install this in an rv. Can you explain a bit more?

I am brand new to solar and electricity, but have done a lot of research, design, planning, and want to be as safe as possible. Have been lurking the forum for a while but this is my first post. Any insight will help me out tremendously.? Setup: Solar Array - 6 panels in 3 series 2 parallel...