MattiFin

I’m affraid you are chasing unicorns here. Conventional panels sounds much better idea especially if you attempt to mount flexible...

Well, do you need reminder? Ok, enough of beating this dead horse for me.

Depends what you mean by fixed from ends. If it has moment(torque) support both ends but floats axially? If both ends are fixed for both...

If you have several panels from same manufacturer it is easier to establish some sort of "baseline" and compare the output to that. If...

Sourcing proper BS or DIN standard barrel butt splices is easy enough and they are not expensive. You just need to shop electrical...

Digikey has bit over 6000 possible matches with input voltage range between 88v and 750v and over 500 different models in stock...

Some interesting forums and posts from my bookmarks: https://www.diyelectriccar.com/threads/dalas-evnx.204062/...

It all depends.. If you are fluent with CAN buses, protocols and hacking and foolishly brave to not to be afraid of high voltage EV...

The 2 first calculators I used are for "simply supported beam" with support on both ends so PL^3/48EI. Thus cantilever beam has 2x...

HB600 would be slight overkill for this application. MT Solar mounts are designed for rated wind for the area, here it is 105 mph.

Did you bother to read? Cases with support on both ends were for 12m beam making it similar-ish to 6 meter beam fixed from one end. Also...

https://www.omnicalculator.com/construction/bending-stress?c=EUR&v=section:6,b:300!mm,t:30!mm,tw:15!mm,M:1920000!nm,d:540!mm

beam supported from both ends but you get the idea: https://sunsetpatios.com.au/beam-deflection-calculator.php 12m span 610UB125 beam...

No need to switch to parallel. You could hypotetically drain the highest reading cells with your electronic load or 12V 55W car light...

Should be ok assuming the cables are not buried inside insulation or anything crazy like that. Note that even two cables(minus and plus)...

There is no easy way to fix the imbalance. Per youtube teardown video the BMS is jbd-hp28sa with passive balancing. I couldn't find the...

Small bridge is not same as tall bridge :whistle: Different sort of engineer (EE-ish) here but can calculate enough to tell that HEB600...

well.. https://www.amazon.com/ECO-WORTHY-Balancer-Equalizer-Supports-Nickel-Metal/dp/B0CKTQF6J9...

Victron has suprisingly good reputation considering what components they use. Hard to imagine that SMA for example would use Ruichips...

Gazillion standards and countries to cover. NEC for single conductors Table 310.15(B)(17) allows 190A for 2AWG...