Recent content by MikeSolarPT

Do you há é AC charging on with 10 amps? Or it is off? From my experience, if you dont have a relativa calibration made the AC numbers Will never BE real. You have to calibrate the PV and the battery to bê acurate. Those numbers Will give a acurate AC reading ( bether one instead of the fake...

My JKBms died to read to cells, so i installed a seplos BMS. So far it is working great with can bus with the inverter. The only downside is the balance current is 150ma but the features that this bms has are massive. The bms send info to the inverter and lowers the charging current when is...

Hi, No. I can only read setting. to change is only possible in the inverter screen. This if was given from sorotec.

Sorotec said that is 20A

Mine is 1155

The inverter uses the battery as power source if battery is available. My BMS, In AC mode , reads 0.77A all night. This is how this inverter works. it seams that idle consumption will came from battery and maybe a part also from the grid.

Grid limiter will only work with the external CT, and the correct operating mode. The PV must be arround 350volts. I never got it to work consistently without a battery conected, but i found if you enable AC charge of battery it will be more consistent. I also read that the load must be arround...

No. the 5.5kw is the max operating AC power. You can peak that but only for a few second till the inverter shuts down. for 7.5kw you hate to parallel 2 units, to 11kw. ( must be the same software version or the parallel will not work.

No 11000wats it the peak ac power for a very limited amout of time.

No. This inverter doesnt allow any modifications by software. it must be done in the touch screen.

You cant change any parameters in yhe software. Only in the touch screen.

I will try to make it tomorrow in the holliday here. you can adjust some things like PV voltage and PV amps ( you will need a multimeter and clamp to mesure amps. ) When you adjust the battery amps and voltage you will get correct grid power. The only down side, in my case is that i lost float...

sorry for my lack of time. I try to make the video tomorrow how to calibrate. Be ware that when i made the calibration perfect the inverter would do float. maybe in your it will, i dont know. In mine i belive that it has to be a amp diference in the battery amp display to the float work. Mine is...

Try contact sorotec power. I believe they can sell you the display.

Yes a see my amps reducing, but in my inverter i select 57 amps and it only stops at 58,but this is a inverter problem, not bms. The bms doesnt regulate amps, it only protect the battery for overvoltage and under voltage in the cells. The inverter must regulate the charging.