MisterSandals's latest activity

400W x 38 x 5h solar = 76kWh per day What are your power requirements per day? How much battery do you expect to have for your backup...

https://support.ankersolix.com/s/article/A1790-Anker-Solix-F3800-User-Manual Q3 in the FAQ at the bottom suggests 60V is the max but...

What is the max input voltage of your SCC? It it’s 100V then you have too many volts in your 3S array (38Voc x 3). What are specs on...

Cells are factory tested to comply within the Working Voltage Range (3.000-3.400 V per cell). The allowable range that causes no harm...

Yea, i wonder what the asterix footnote says...

Then you need a switch to handle your panel Isc now and 2x Isc down the road. sorry i wrote Imp in previous post. Correcting.

What is this? Is that for an external load? I have the same tester and my understanding was that it messed up the readings of the...

Are your panels connected in series or parallel? If all parallel, you need each fused to 15A and your switch needs to handle the Isc x 4.

It can be setup as either. Single is 120V output. Split is 120V x 2 with each leg in a different phase (common household 240V). It...

Thats 600Ah x .2C max as per your specs = 120A max 60A recommended Its important to have your batteries wired in a balanced manner so...

I am not familiar with the plastic cased cells. The video looks like the cell compresses easily and might just be a bowed case? Does...

The PD 80A charger looks good. They fixed their float voltage to a very reasonable 13.6V. Too bad their bulk charge is not programable...

What is the MPPT (optimized range) of your SCC? This would be pretty rare but its a good thought.

Using 4 3.2V cells to make a 12.8V battery. The BMS size rating in amps is determined by your max expected loads. If you will have an...

You need to calculate (not guess) your power needs before an inverter of the right size can be recommended.

Sorry to hear you were part of the Lahaina tragedy. Best wishes moving forward. Lets get started using the correct units: 48V and 100...

Is charging terminated by the SCC with all cells 3.65V or is there an over volt condition? I'd be WILDLY surprised if SCC terminates...

26.8V corresponds to 3.35V per cell. This is the normal resting voltage after charging has stopped, or a load is placed on the batteries...

Can you post a pic or link? These won't do much for a big 12V battery other than maintain a charge.

40W x 24h = 960WH Refrigerator we usually use 2000Wh per day Water pump... 17A at 120V? 5 minutes per day: 17A x 120V x (5/60...