Recent content by navillus

Awesome! Thanks.

6awg is what I meant, typo. Ok, understand your rationale. Thanks

Thank you for the information. Inverter runs about 83 amps, 100 amps factors in efficiency. How do you figure 2awg wire from fuse block to Busbars? I have under 20amps of draw of The fuse block. Thanks

100 amps inverter draw, 20 amps Dc fuse block.

Using a 200Ah lithium battery. I am looking for fuse sizing for the bolt on battery fuse. Maximum load on the system is 120 amps with everything switched on. Should I use a 150amp fuse or a larger fuse like a 200amp? Any information is much appreciated. Also wire size chart shows 120 amps I...

OK, that's good information, let me look at cable proximity. Thanks.

Not sure what the full reset amount is, and how one would reset that to a higher figure?

Thanks anyway!

Great question! Only with load.

It reads zero, for amps and battery %

My AiLi battery shunt works great, until, I turn on my inverter. When I switch on my inverter, the shunt will measure the power usage, however, it deletes the battery power % and Amp hrs information. Has anyone else had this issue? More importantly is there a fix? Thanks

Manual says input voltage.

I have entire system grounded to chassis from her bus, with 4/0 cable. Inverter, mppt, power converter grounded with 10 awg, which is either manufacturer's spec or exceeding.

Checked that out, does not address exactly what volts to input.

I have a 12v system. when programming the device, do I simply set the volts in the AiLi shunt to 12v? I have a SOK lithium 206 Ah battery (another on its way). Thanks