Recent content by Neon

I am wondering if your batteries have a metal or plastic casing? The pads I purchased says to apply to non-conductive surfaces. My SOK batteries have metal cases.

Thanks all. That is the info I was looking for.

Yes, 4 panels in total, but there will be two different systems. 2 Panels with its own wire run and MPPT. Hope this is clear.

Perhaps I should have placed this in the Vehicle Mounted Systems category. This will be on an RV, and the 1700W (2X 850w) will physically max out my roof. Probably should have mentioned this, but I was trying not to cloud the original question on wire size. :)

I am getting mixed messages on what size solar cable I need to get for my project. Not sure if I need 10 AWG or 8 AWG. Here is what I am going to be using: (2) 425 Watt panels Each panel is 48.1v VOC and Imp = 10.31A Going to feed a Victron MPPT 150 | 70 Tr charge controller Somewhere around...

Yep, will have some insulation on the floor.

From what I have read, the SOK’s can be positioned on their sides.

Due to the limited space I have available in a compartment bay of my RV, I have to stack my batteries as shown below. I am trying to understand the best way to separate the batteries (if I separate them at all). I am installing (4) SOK 206Ah batteries, that weigh around 48 lbs. each and have...

Due to compartment sizes and the very large sizes of the batteries and Victron components , I may have to place the MPPT charge controllers in another bay. So, the solar panels will be approximately 12 foot from the MPPTS (8 AWG). Each MPPT will control (2) 425 Watt panels connected in series...

Your buss bars came out nicely!

The disconnect switch is continuous rating: 350A and 600A Intermittent. Not sure of the SOK's.

I love when someone knows that they are doing...I am just fumbling my way through it, but so far my components seem OK. That is why I was logging for a robust Link Bus.

To be honest, not sure how much I am going to pull. My components are: 4 X 206 SOK Batteries 400a Class T Fuse Blue Sea Systems - Battery Switch 350a continuous 4/0 wire Victron Energy MultiPlus 12/3000/120-50 Going to be running everything in the RV from this...including the AC. BTW, AC is...

Yes, I believe those will work! Thanks. I did not know they had a name.

The battery bus bars for cells look similar, but their amperage ratings appear to be smaller that what I would need. Need 300a-350a continuous.