Recent content by Nillerk

I'm not sure I would classify a Victron Multiplus as a "cheap" inverter. Either way, it does have a low draw switch that switched the ac to a pwm on low power draw.

Thanks for the feedback. Any thoughts on when the 2nd BMS functionality will be ready? Here is the charts for my MPPT

https://m.aliexpress.com/item/32821877897.html?trace=wwwdetail2mobilesitedetail&spm=a2g0s.9042311.0.0.70ce4c4dbzdY3p Why would my furnace show up on my multiplus? It just runs on the a dc circuit with propane

@Louisvdw , I am hoping I can get some feedback from you on my linked post. https://diysolarforum.com/threads/confused-about-where-my-power-is-going.23213/

So I finally got the trailer all wired and went out for the weekend and the 600ah battery bank that I was expecting to have about 7.200KWH of reserve ran out after only 2.5KWH according to my Victron setup. Wondering if anyone can help me shed some light on this. System: Victron Multiplus...

I don't think that was electroplating. I think he was just using an acid to clean the copper before rebuilding.

I do 5v ~1A for 30 mins then flip and another 30 mins

E3d NozzleX

I was using a torque wrench set to 8nm. It was for sure tedious

PM me your email and I will share. I am exploring selling these but could use a couple of beta testers.

https://www.alibaba.com/product-detail/CATL-batteries-3-2V-302Ah-302ah_1600196314789.html?spm=a2756.order-detail-ta-ta-b.0.0.151b2fc2GiycdM They changed the listing to 302ah now though...

Fusion 360 Prusa MK3s

Thank you :D

I was drilling out the bus bars while holding the bus bars. I snapped the plate off my drill press a few weeks ago. Plus I'm an idiot...

The whole case takes about 3 days to print. I used Carbon Fiber PETG for it so it is super tough.