Recent content by oldcat

yea i bought 4= 100 ah batteries from rebel Battery and i am having problems with mine to.. eric will Not Answer None of my emails about a month now this is not good that means the 5 warranty is No good.. im starting to see Bad reviews every where Now...

store bought

hey you all i just charge my 100ah lifepo4 batteries and the Bms is showing batteries cells out of Balance i need to know if this is Not Good.my batteries are hooked up 12 volts the positive wire on one end of the Batteries and the negative wire on the other.. the batteries just Got charge...

is you AMPINVT inverter still up and going

this tracer-BN-series 40amp when i change it from 12volt-to-24-volt now the battery green lead is flashin really fast and the warning lead on the MT 50-meter is on.. it says voltage-overload in the manual... i see nothing in the manual about this not switcahig automically............ my other...

im changing form 12v to 24v do i need to do anything on my epever tracer 60amps 6415 an-- charge controller.. or is it all automatic when i turn it all back on when im done. thanks..

this is a stud mount fuse and it should have work just fine on the copper on copper lugs with a bolt .. i took it off and no more heat..

it just the bolt & nut--- getting warm not the fuse and i already clean with sand paper.and still on go the bussman fuse looks legit and im only putting 60 amps thru it.... this is dumb the fuse is new.... i guess the fuse is no good............

i had no problem with heat on this when this was bolted to my battery before i put this fuse inline if i take the fuse out no heat but that not safe.

are you saying i need a fuse holder for this agm..... fuse is in direct contact with lug. washer is on the back side

no washer between lug copper on copper and is real tight ..this isn't making no sense....

here is the best i can do. i have 4 6volt crown 205 battery hookup as 12 volt.

Hi i have a bolt on fuse on my charge controller on the battery... with a 4 gauge wire 6 foot long and the fuse only get awful warm just at the bolt im using to connect the 2 ware the 2 crimps are good they are not getting warm.. i also clean the 2 brass ends where they connect.. im using a 5/16...

i cant see it in this picture.