Quankl's latest activity

Understood and will rectify it. But within my operation I never pull more than 20A from a battery. 40A total from the bank. 40A on 6AWG...

Fully updated both batteries. I was on old 3.32. Also looked at the issue of resistance so I swapped the cables around. (Was POS on top...

Mine goes from 110-170 sometimes depending on load. Less load usually gives me higher idle.

4 days of full 48/49v cycling. 0% till full SOC. Still have this low cell. Tried holding it at 55v float for many hours. Its still...

Well no change. But everything seems to be working. I'm getting solar power and I'm getting AC output from batteries so I'll leave it...

Ok. Got it. So I tried last two days on weekend where I could monitor it 24/7 with the provided settings. Couple things I noted...

Idk I think I got scared here when the first pack hit 0.0% reported by the BMS but the cell voltages still seemed to have more juice in...

Fully discharge to what voltage or SoC? Just want to be specific. 5%?

Didnt get opportunity today to update the firmware as i had to leave. But just followed a test with some screenshots attached. 56V...

Looks like 3.32 on the lower corner of the BMS tools screen. I know it's not the latest but I have pretty terrible luck with updating...

And just to show. This is why I can't use EG4 comms. OV protect is 3.6 and alarm is 3.55. EG4 sends it to 58.4. thats 3.65. everytime...

Seems random. But today now. 56.2v bulk and 54v float when it hits 54v charging slows and current falls and that SOC is like 70%...

Yup. I did. The SoC magically changed to 100.3 instantly. Not sure if it was just stuck at 98.8 after charging had stopped with my...

To the part on the BMS and PC I don't believe you get access to change any parameters on eg4 battery and On the point of the voltages...

Me yet again, I have a question. When I am on EG4 BMS comm mode the voltages go too high for my liking. I resorted to User mode...

lol. NO hub. I do not have a hub. I got it figured out though. the issue was the battery was in protection mode it seems. EG4 values are...

Oh no hub. Sorry I had to set up.

No same exact setup as yours. Just I have the normal Lifepower 4 batteries without LCD. And Pi Zero 2w. I set as user and will test. I...

I put it in user. EG4 mode is pushing the batteries up to 57.6V and triggering the over protection... It's constantly pushing 5amps into...

Same. But eg4 mode somehow sent the battery into Overvolt mode.. idk. It's issue after issue with this on my end.