Most reacted posts

I appreciate the info, I will, like you said, series the batteries after charged full within .10 and use the inverter. Kinda a pain because of where I put the batteries. I have to pull the component board and open like a door to get to them... and it's a bit of a reach.. but i can do that. The...

Only issue I have is using the power after charging in parallel... the inverter is 24v. I suppose I could hook it up to the 12v system and run the lights / fridge DC. Any suggestions? With the weather right now, it's time consuming to charge, let alone discharge @12v without the inverter on...

First DIY RV Victron system. After finishing install and setting parameters, I allowed the system to run for over a week before finishing up by connecting a Orion 24v-12v converter to my factory lead acid batteries (two wired in parallel). System worked perfectly, with 0%-.10% deviation between...

Also, the factory 12v Lead acid batteries Negative goes to chassis ground vs back to main panel (diagram above shows pos and negative back to panel) whereas the factory wiring has a positive from batteries to panel, and negative to ground. Since this was working fine I didn't run a negative to...

Hello, My RV is not being used at the moment, so I wanted to use the AC-out-2 to power a 120v mini-split for cooling the house vs the Central AC. I know i can input this into the AC-out-1 and accomplish this, however id like to still have the ability to use power in the RV when needed. So...