Recent content by Ruben

I just found a rectifier and connected the 3 ac wires from the turbine on it Measured the dc side and i got like a constant 30v and max 60v output

I got a free missoury wind and solar wind turbine, Its 48v 1500 watt Down side is : i dont have a rectifier and no charge controller Will any simple/ cheap chinese controller work on this turbine ?? I dont want to spend a lot of cash on this project Btw : my solar system is also 48v Your...

Wont the different solar array volts and amps from the 2nd mppsolar affect the 1st system??? Or will it just add volts and amps from both systems ? Remember its all going thru the victron smart shunt on the negative battery cable

I have a solar system allready for about 4 years with a nissan leaf bat bank and wanted to upgrade my system The 2nd mppsolar inverter ( which i got free) will only help out with charging the battery and will have its own small solar array All settings will be the same , negative cable will go...

Opinion 2 mppsolar inverters Each has its own solar array Connected via victron smart shunt , charging the same battery bank All settings are the same , bulk, float Low bat voltage etc etc etc will this work??

Bump

Hi guys Your opinion on this setup 1 nissan leaf battery bank 8p7s 2 mppsolar inverters pip 5048gk each has its own solar array 1 victron smart shunt Bulk 57.5v Float 57v I want the 2 separate mppsolars charge the same battery bank via 1 victron smartshunt All voltage settings will be the same...

Hi guys im gonna buy some used solar panels at sunelectronics international in miami florida 15901 nw 59th ave in miami lakes 33014 so i wanted to know if you guys know the place , have bought panels there , good quality used panels etc etc Ive been recommended to them via this page , but i...

Hi guys im gonna buy some used solar panels at sunelectronics international in miami florida 15901 nw 59th ave in miami lakes 33014 so i wanted to know if you guys know the place , have bought panels there , good quality used panels etc etc Ive been recommended to them via this page , but i...

Got it !

Btw The panels are used and each measure open circuit around 31-32v So 10x 32 v = 320v open circuit on the roof But how come i get 220ish with the panels connected at the breaker that goes to the inverter? if i disconnect the panels at the breaker from the inverter i get the 320v but as i...

Wow man Im gonna read that 5 times !!! Thnx a lot

When i measure on the roof , its disconnected you can say open circuit of the 10 panels in series

When i measure on the roof , its disconnected you can say open circuit of the 10 panels in series As soon i connect the panels and measure again at the breaker i get the lower voltage