Recent content by sabo

On a side note after multiple attempts to setup the built in wifi I was unable to do so. I wonder if the firmware flash at the factory is bad?

Just to be clear the reading from the connectors that are attached to the array is 204V. While that was disconnected from the inverter I took a reading from the MP4 connectors attached to the AIO. That reading was 29V.

I just read that it was 29.65 volts

I disconnected the connectors from the AIO and took a DMM reading from the panels. I read 204V with the PV array disconnector switched to on. I then took a DMM reading from the PV input connectors which was 29.65 volts

This video is called batteryless mode but it is clear he has batteries attached. Youtube Video of batteryless mode,

oops sorry about that. Yes according to the forum some users said my LV6548V will operate in SOB mode which will allow batteryless operation. Youtube Video of batteryless mode, The above unit is LV6048. a DMM reading of PV voltages at the PV connection terminals of your AIO would be a good...

I dont want to rely on battery power. Is there a minimalist battery I can use (cheap) just to run the inverter off Solar and then Grid Backup?

oops sorry about that. Yes according to the forum some users said my LV6548V will operate in SOB mode which will allow batteryless operation. Youtube Video of batteryless mode, This video is called batteryless mode but it is clear he has batteries attached. The above unit is LV6048. a DMM...

I turned off AC power and the inverter turned off. I took a reading with my multimeter from the PV array DC Isolator output and its 204.5 volts 6P2S is my array setup. Bad Connectors in the PV input on the inverter? I just tested the cables from the PV array isolator and the cables read 203.5 V

Any experience with MPP Solar SUB mode. Solar then utility? My setup is no batteries, one LV6548V 12 panels 6S2P into one MPPT. I am looking at the programming menu: setting The inverter menu does show SUB mode and that is the setting I selected. The screen shows the Grid Icon and by pass...

My setup is no batteries, one LV6548V 12 panels 6S2P into one MPPT. I am looking at the programming menu setting one. I only see USB and SBU settings, no SOL. Does this make sense? INPUT is 120V on the display OUTPUT is 121V. I have a 6P warning which means battery is not connected. Any...

I am looking for an enclosure for a Solar Disconnect Switch, PV Isolator IP66 Waterproof. The one I purchased will rot in the sunlight as it is sunny here from sunrise to sunset 93% of the year. Any recommentations? Solar Disconnect Switch, Waterproof

Are you familiar with this brand? I am thinking about upgrading Ultimate Nitrile Grip Work Gloves What do you think?

I was also worried I had shorted something or that the connectors were faulty /bad. good to know it was just that I dont know how to read a solar panel power diagram :( Good to know. I try to not ever work on live wires but was wearing gloves with an abundance of paranoia.

I was under the impression under load was when I was pulling power from the power source. Like a motor running on AC power. Ex: when the motor is running its under load. So does this mean that a solar power in the sun is considered under load? I know there is power is available when the sun...