Most reacted posts

Rough schematic attached

Look into the features of the eg4 chargeverter I think you can adjust the amps in range for the inverter. Not sure . Expensive work around but maybe there's a similar device out there

Subpanel in a different bldg gets its own grounding rod but remains unbonded ? I'm struggling with that. I have a duplex with separate meters the inspector made me detach the ground and bring it to one main ground. So from 2 meters 2grounds TO 2meters 1 ground. Of course these 2meters share a...

I was thinking my array is to big for my inverter . So can I use charge controller(s) . Array to controller(s) to battery bank to 6000tl-x inverter? Since I am using zero export my inverter will pull power from the battery after the sun goes down until the batteries are depleted. Any ideas are...

I have been looking for the same info. I even asked growatt. The response was no battery hook up. But my question was Why what prevents you. The only thing l can think of is amps/volts

You'd have to be over the minimum volts maybe 96 and under the 12.5amps

I can not answer you with absolute certainty. But I believe in the very least electricity flows to the path of least resistance and the inverter will produce only what it can to offset the load. That's if the sharing of a load happens. If the load shuts off the inverter Mosfett will click...

Another possibility is figure your minimum usage at any moment set your production to that x 24 use your batteries as the buffer. Simultaneously feed larger loads thru other inverters in grid assist. So every bit of produced power is used on site and bill is as low as possible. I have been...

Did you resolve this issue?

I too am very interested in the true features of this zero export. I have a growatt Min 6000 the ct clamps are to be attached to the meter and the meter to the inverter. On those models. My understanding from reading the tech flyer on zero export for the MIN models and emailing tech support is...

This is what Ive come up with so far. And I could be wrong about any of it. The battery amperage is to high to come through the solar array inputs. It's not a problem bro wire two 48v batts and get to 96 but how do you limit the amperage to 12.5. a 80-550 vdc to96 converter with a 12 amp limit...