I have 55w 30L fridge and it runs on 100Ah 12V battery for 5 days to 10% rated capacity this is real life number. With 25C degrees temperature deferential (on average ) between ambient and fridge interior. I also run it in Eco mode when on battery mode and it consumes only 2A at 13V. Your...
You sure about 15sec? I thought there is no delay at all.
I would like to have 5-10 minutes delay to give starter battery time to charge . So I don't have huge total amp draw on the vehicle alternator on start up.
I definitely won't find the thread. But you can try plugging in your bms in a power bank.
Again are you sure about your red wires from bms to the cells
Get 28V charger!
Take a picture of your BMS. Is it's smart one? I recently had issue with my 60Amp 4S smart BMS. Double checked wiring no issues. Until I opened my diagram and checked wiring 3rd time and "BOOM" done.
So make sure you wiring is correct even if you so confident.
I found on...
I gave up on them at that point I will use BMS to allow charging, later after car starting or just manually plug in battery.
But I appreciate info you provided. Learning curve for me.
Cheap kick stand for a portable flexible solar panel. Need PVC water pipe 1/2 in, velcro tape and 3D printer.
It's not going to hold high winds but will work for camping needs, very portable.
Adding ignition delay timer to my Renogy DC-DC charger. Hopefully Renogy will improve their charges by integrating delay time in a future.
Updates: stay away from this timer it's working only with trigger switch not supporting constant ignition power.
What's wrong with flattened copper tubing? Why you don't like it? I know you can buy, but sometimes the lengths is the issue, if its not standard assembly. Or if you need to make 90degree buss bar, copper tubing comes handy. You can do nickel plating or solder plating.
Grade L tubing its 99.9%...