I am having similar on spf 3000tl lvm.
Lcd shows panel but no lines to indicate charging. Led charge light blinking, only voltage shown on lcd pv voltage is the battery voltage. Pv @ 110-113v tested from array down to breaker to unit. Shunt display shows several hundred watts in but in full sun...
My dual spf 3000tl lvm have a setting 22 for solar power balance which on those units run fine enabled. The spf 6000/8000 do not have said setting though.
I am having similar issues.
Spf 8000 + 6000
2 lfp banks 280ah
Both units (same system swapped units)
at full charge or cv of 57.6v shut power for short bit (long enough to throw clocks to reset, lights out, etc)
I assume it is the transfer time when shutting/ throttling array down to meet the...
A lot of us are in the same boat with these units.. Here is the thread about the problems and the issues it causes with neutral and grid..
Long but a must read..
I am still trying to figure/ settle on a solution as well.
https://diysolarforum.com/threads/growatt-12k-passthrough.37359/
Blue sea and othe class t fuses also have a high AIC and offer ignition protected blocks..
Amperage
225A
Maximum Voltage
125V DC
Stud Size
190
3/8"
Interrupt Capacity
20000A @ 125V DC
Weight
0.30lb (0.14 kg)
I use the midnite mnedcrt 175 and 250s
With AIC 50,000 @ 125VDC handled remotely in an enclosure and they are around 7".. not crazy huge...
From their website:
MidNite's breakers are rated to break the full rated load at the rated voltage repeatedly, with NO DAMAGE. Always use a properly sized...
Yeah I do see a lot of lfp banks "hidden" away but I rather enjoy seeing everything involved. It definitely is a conversation starter -even without the lights going.
Mostly though people can't get over what all I run off of that bank and my system for its size.