Well everyone I thank you for your help - the issue is resolved!
a battery monitor I’d installed had been losing power due to wiring inefficiency and a loose connection. Fixed that and everything else fell into place.
Again thanks for all of your help-it’s a huge relief to have this issue fixed!!
Alright here’s a dropbox link with some photos - I can’t seem to upload them to this forum for some reason?
https://www.dropbox.com/sh/i7wpvu6xl89ecqu/AAA-W4HZJ_F1Q6YTSRQCmQZQa?dl=0
Sorry for the late reply- hell of a week. I made a mistake here. 6 awg wire for all battery connections, 1/0 awg for the inverter and 4 awg for the 100 amp charge controller (110 amp circuit breaker connected).
it’s hard to get a clear picture in the crawl space so I drew some diagrams.
the...
I have four 12V 170 AH BigBattery batteries connected together in parallel, that are then being split into two outputs with a reversed parallel cable. One output runs directly into my RV while the other leads to a 100 amp Renogy solar charge controller (1200 watts of solar panels are connected)...
Hello! I'm new here but have been reading Will's book in an attempt to set up my solar system.
I'm curious - would my 100db of Gain Cell Signal Booster (Cel-Fi GO X) interfere with my current setup in any way? I know inverters can cause interruptions in radio frequency, but would the cell...