I’m using 3x DIY 190ah batteries each with a 4S Overkill Solar BMS.
What Cell Cap. Voltages are recommended for 10% up to 100% and everywhere in between? These are my current settings which don’t seem right:
Got it, for some reason I thought panels were more dictated by volts than amps, as in amps we more of a constant if in the sun and it was the voltage varied. Now I feel stupid. I appreciate the replies!
I have 2x 200W panels on my van that were producing around 350W Pmax a few weeks ago (closer to 400W P max in summer). I just noticed now that output is around 200W P max. The V max is the same at around 40V.
I cleaned the panels as they were a little dirty, it made a little difference of about...
Thanks but I'd order then from Ali if I had the time to wait - I'm looking for something available now. Good idea to bring some in though!!! They're impossible to find in the US.
Anyone know where I can find a battery case in the USA?
These ones are quite bulky:
I'm looking for one like this but can only find them on Ali Express (I'd like one from a US supplier to get it ASAP).
Hi all, I have 12x 3.2V battery cells. They've been split into 3 separate units of 4 cells in parallel in order to level out out the voltage (since I wasn't planning to use them for a little while). Each battery the 3 batteries has 4 cells with the same SOC, although each battery has a slightly...
I think you may be referring to the non-isolated version? I purchased the isolated version. I haven't got to the wiring of them yet, although off the top of my head I think I will wire them independently of each other (perhaps with another busbar at the battery so the terminals are clean & I can...
Hi, I haven't installed this yet (the build is slow with kids and a business) but I have all the parts in my garage and I have decided to go this route of wiring the two Orion DC-DC outputs into a busbar (one for + and one for -) then feeding from the busbars into the Lynx Distributor. I've...
My Lynx Distributor has no room for the 2nd Orion DC-DC and I'm trying to avoid getting a 2nd Lynx Distributor. Can I wire the Orion DC-DC units in Parallel from the Starter to the Orions, then feed their outputs onto small busbars (one + and one -) that then feed as one cable into the Lynx...