Recent content by ZeeMox

Word. My jbd bms is made to handle significantly more cells than 8 on a variable basis. The wiring for 8 cells calls for almost all of the extra wires to go on cell 6 or 7. Seemed kind of odd to me but has worked out. These are the 280ah Eve cells sold by Docan Power. They came with terminals...

Thank you, "terminals" was the very basic word my brain was sundowning on last night. I'm currently getting out of the door for a trip across the country, so I don't have time to disassemble the battery at the moment, but i think the two small lugs were thick enough to cause the terminal to spin...

Roger that. I don't have a torque wrench, but I'll acquire one before I go playing doctor. Sorry, sunshine_eggo, been a long day of doing a lot more than trying to solve my battery. I see that you're absolutely correct and the cells only appear balanced when they fall below 3.4 volts. The...

Alas, I left the charger on for several hours and the balance improved only minimally. I then turned the charger off and it was completely balanced within 20 minutes. Turned it back on, and the same cell fell behind immediately I guess I will be opening it up tomorrow and checking all the...

Thanks, that makes perfect sense.

Thanks, I'll double check all that. The balancing values you refer to are "balanced turn on voltage" and "balance precision", right? Can you help me understand why having it balance later and reduce precision would help the cells stay in balance?

Hey everyone, recently built a 24v battery with the help of Will's resources and the helpful folks here on the forum. I top balanced them to 3.65 in parallel before assembly, but it seems they haven't reached 3.65 upon my next attempt because one cell is lagging behind? This is a jbd bms and the...

Thank you guys so much. Don't know why I didn't think of the impact gun. Even with it, it took a lot of work to get B- off. They appear to have used some thread sealant on it. That was my last hiccup and now I have my first working DIY battery assembled and functional :)

This thread concerns the bolts/nuts holding the thick black/blue cables on my JBD 200A BMS. These are 4 AWG cables, and using the information in this thread I established that for my battery, it would be wise to replace this with 2/0 cable. Problem is, these nuts are so tight that there is no...

I missed that detail, thanks, making sure that's done from here on.

I've got 8 280ah eve cells connected in parallel. They all came at 3.27volts, so after getting them connected I hooked them up to a 10amp lab DC charger set to 3.65. Important to note that I was only getting 10 watts initially and it's been hovering around 30 watts ever since I crimped some 8ga...

How? I found boxes for groups 24-31 that are only 1" longer than the cells themselves, and about half as wide as I need. Even this super long box is an inch or two short to put them in a row. The DIY wood projects look pretty effective. Leaning that way if I can't find a decent box.

Great, thank you! Especially for the math on the amps, very helpful.

I don't possess the inverter yet, most detailed specs I can find are on this page. I don't see a specific value for the low voltage disconnect. Is there a typical range? If I'm reading the manual correctly, the BMS defaults to 300 amps over-current disconnect.

I've established that I want to carry the load in my system with 2/0 awg wire. It's 24 volt 280ah and I want to be able to use a 3000 watt inverter. The JBD BMS I got already has 4 awg wires and lugs attached for two negative leads. I'm wondering if I should replace these with 2/0 awg as well...