diy solar

diy solar
DALY BMS Monitor to monitor 8 boards

DALY BMS Monitor to monitor 8 boards v1.2.5

Using this version of DalyBMSMonitor, I was able to monitor three BMS on the same RS485 bus.
To change the board number, connect each BMS SEPARATELY first, go the tab "Engineering model" and find on the right side "Read" next to "BoardNo:". Initially this will show "1". Change this to a number between 1 and 8 and press "Set". Then you need to change the board number tab above to the number you've just chosen and go to the tab "Data monitoring". Repeat these steps for all of your BMS.

DISCLAIMER: I JUST TESTED THIS ON THREE BMS THAT WERE ALL IN PARALLEL. I AM NOT SURE, IF YOU CAN CONNECT BMS OF BATTERIES THAT ARE IN SERIES (i.e. two 12V batteries forming a 24V system).

You need to upgrade the BMS firmware on each of your BMS first (see other ressource "DalyBmsApp_20210216B.s19").
  • Change board number.png
    Change board number.png
    105.3 KB · Views: 736
  • Like
Reactions: Pismar
Author
KaFun
Downloads
699
Views
3,651
First release
Last update
Rating
5.00 star(s) 2 ratings

More resources from KaFun

Latest reviews

Works perfect. Thanks.
Great help, thx
Back
Top