To get this paper, click on the orange
button at the top of the page
I stripped out the M6 threads in the terminal hole of an Aluminum Case LiFePO4 Cell.
This deck shows what I did to drill out the hole and tap for an M8 hole.
Revision 2: Added slide about using studs vs using bolts or screws.
Note: I am *not* a machinist but I have tinkered with metalwork. This is what I did but a machinist might have a better way.
Suggestions, comments & improvements are welcome.
I stripped out the M6 threads in the terminal hole of an Aluminum Case LiFePO4 Cell.
This deck shows what I did to drill out the hole and tap for an M8 hole.
Revision 2: Added slide about using studs vs using bolts or screws.
Note: I am *not* a machinist but I have tinkered with metalwork. This is what I did but a machinist might have a better way.
Suggestions, comments & improvements are welcome.