diy solar

diy solar

Search results

  1. D

    Daly 200A BMS odd readings

    BTW, it talking with the tech support at Daly, it is "normal" for the BMS to report very high currents and also show odd readings on the other sensors when it switches between charge and supply. I thought it was a bit odd but they say it is normal and by design!
  2. D

    Daly 200A BMS odd readings

    Are you referring to the initial setup or the picture I posted this morning? You'd rather see the large cables under the buss bars I have the sense wires attached to??
  3. D

    Daly 200A BMS odd readings

    They all measure exactly the same via a multimeter (within 0.002V). No reason to top balance them if they are the same to begin with. I did do it a couple months ago when I put the battery into service. Thanks for the suggestion...
  4. D

    Daly 200A BMS odd readings

    I figured I would post a follow-up to my thread. Daly has been surprisingly responsive to my questions and concerns so I give them props for the support they have given me. I did some bench testing using a huge box fan and an inverter trying to figure out what is going on. My findings were...
  5. D

    Daly 200A BMS odd readings

    I have been going back and forth with Daly on this problem. It is blatantly obvious that they believe the problems I am experiencing is my fault. They are blaming either my wiring or batteries. I have asked multiple questions that they refuse to answer. It is frustrating to flush $200 down...
  6. D

    Daly 200A BMS odd readings

    Unfortunately I need one capable of at least 200 amps. The largest one they show available is 150A. Back to the drawing board I guess??
  7. D

    Daly 200A BMS odd readings

    That is not the answers I'd like to hear :-(. It was working great though!! Guess I will reach out to Daly to see if they can warranty it. I wish there were more options available that were priced decent / inexpensive.
  8. D

    Daly 200A BMS odd readings

    My system consists of 400W of Renolgy solar panels, 280aH LifePO4 battery, EPEver MTTP charge controller, 3KW inverter and the 200A Daly BMS. All connections are secure and my balance wires are attached to the buss bars via tapped holes using screws. All grounds (2AWG) go to a buss bar and are...
Back
Top