Search results

UPDATE: Found the issue. I run two identical arrays to two separate charge controllers. I thought I was careful not to mix wires from array to CCs. I also assumed that the negative wire from array 1 and positive wire from array 2 wouldn't charge since its not a complete circuit. But I...

That's a good point, I should double check what state it's in.

Sure. I have the Mt50 and Solar Station on a PC I can gather metrics with.

The amps coming from the PV array will stay at just a couple of amps, but after a reboot it will climb to double digits.

I have a pair of Epever 80 amp Tracer AN. Seems I see quite a few posts around odd behaviors from the Epever CCs. It worked fine for a couple of months, but now likes a reboot.

Hi All, I'm finding that rebooting my charge controllers everyday greatly improves performance. Doing this manually every morning, disconnect PV arrays then disconnect CCs from battery's then reverse it back on. Wondering if there is a device I can install that will do this at a set time...

Have you watched the Adam Welch videos?

I've gotten the apps to work and updated settings on my two parallel Tracer AN charge controllers. For the PC version in using Solar Station with the cable. But for Android I use the WIFI module and the Lithium app, even though I am in Lead Acid it works. Assuming you made the changes in PC...

I'm finding almost every day I have to perform a reboot of my two charge controllers to get them to charge at a higher rate. Sun is out, batteries have room, but just charging at a couple of amps each until I disconnect the panels then disconnect the CC from the battery and the reconnect...