Search results

I finally bought the rec bms. 750$ total. Now the Jbd for sell.

I bought a Jbd bms with canbus. Will that work or it need to be some special protocols built in ?

I had one already. And now it on lithium

That the only warning

Done thx

I put one 10k resistor. It read 71c two ready the same. What should I do?

Do I did selected 50mv. Do I need to sleep too 500amp? I got a 500A version

I installed a shunt and hookup to the sma

Thx…but the sma didn’t read the current going to the battery

I installed the temp sensor and the shunt..but SOC still 0. How do I reset it?

Using lithium. REC like another 700$

In the manual I also see the midenite comm adapter. Do I need that too?

Thank you very much

Thank you. And how to set the low voltage shut down off. I don’t want the inverter shut down about 30%

In order to make it work I need five of them? And where. To set the temp coefficient? Thank you

Finally the sma temp sensor and the 10k resistor arrived. But the sensor is 1.981k ohms. And the 10k resistor still work?

Finally the sma temp sensor and the 10k resistor arrived. But the sensor is 1.981k ohms. And the 10k resistor still work?

Bought 2

I bought this already. If I put the resistor. I should use the 10k?

mine is 50mv

i have this in my garage.

I called them today. They told me I need the shunt too. But I checked eBay. No luck. Anyone know where to buy?

I have 12 300v panels

I charge the battery through the solar charger. No charge from 6048

I don’t use the sma charge the battery. It only invert.

Found this on eBay and renergy has the same color wire. Will that fit? But price is ten times less.

I already ordered the temp sensor. But still missing the 4 pin terminal. Can any one check the size of the terminal so I can buy the correct one. Amazon has 5mm and 5.08mm

Sometime 2 days working. And today it drop out 4 times

I am not there. Tomorrow I ask my brother check the code and report back. Battery is fully charged

I recently bought a 6048 without temp sensor and. Urgent sensor. 480ah LFP battery with a JBD bms. I use FLA battery setting totally off grid. One morning i woke up. No AC power. And checked the 6048. It restarted. So I have to hold the enter to turn on the inverter again. I don’t have heavy...

if you draw more than 70A...don't use sperate port....i learn my lesson.

don't do that...if you buy a Daly bms. they are not design for that....buy a 16s BMS. save you headache.

Daly. They told me not to parallel them.

Parallel. All battery same size. I have 16. And want to run 2 group of 8.

I am currently have 2 sets of battery with different BMS. One with com port, other one is separate port. I want to know if I can use them together or not.