Hi,
I have assembled a 4S 12V nominal pack using a 120A JBD BMS.
I have hooked up the capacity tester that comes on and works, however I cannot seem to get the Amps above 4A! which is around 50W. The unit is set to 185W max
When I start the unit up both knobs have been turned counter clockwise to their stops
I have tried
I have assembled a 4S 12V nominal pack using a 120A JBD BMS.
I have hooked up the capacity tester that comes on and works, however I cannot seem to get the Amps above 4A! which is around 50W. The unit is set to 185W max
When I start the unit up both knobs have been turned counter clockwise to their stops
I have tried
- turning the both knobs very, very slowly
- turning the unit off for 20 mins (including disconnecting it
- Trying a few times...