What do you mean? Recommended for what? Please provide a lot more specifics.but see 60 amps is now recommended
What do you mean you see it is 'recommended'?Have been running a 30 amp Epever MPPT charge controller on my 600 watt 12 volt solar for several years but see 60 amps is now recommended,
just wondering if the performance or increased output would be worth it?
Have been running a 30 amp Epever MPPT charge controller on my 600 watt 12 volt solar for several years
That is what my understanding is, your table verified it, where did you get the chart...seems my controller is working within perameters then.How many panels wired how?
Mounted tilted or flat?
Do you ever see your SCC putting out the full 30 amps? You're likely not getting a full 30A from your panels. Your array size and controller size ratio is known as 'over-paneling' and it rather common. If your panel current goes over the charger capacity it simply doesn't utilize the excess past the 30A output rating. So you might lose an amp or two at peak.
You are over the upper end of recommended total capacity for your 30A unit, even for a 40A one.
EDIT: I was looking at 24V rating - if you're charging at 12V your 600 watts is probably not being fully utilized.
Your setup can be "within parameters" and at the same time still be limited by the charge controller.That is what my understanding is, your table verified it, where did you get the chart...seems my controller is working within perameters then.
That is what my understanding is, your table verified it, where did you get the chart...seems my controller is working within perameters then.