cmpct_cmpr
New Member
- Joined
- Sep 28, 2020
- Messages
- 17
Hi everyone,
I remember reading here on this forum that some people 3d-printed cases for their DIY battery banks.
I'd like to pack my 4 280-Ah-cells and a BMS into such a box. Nothing fancy, just a simple box with 310 x 230 x 200 mm (L x W x H) INSIDE dimensions.
The lid could be fixed with screws, no need for a complicated hinge. I would drill holes through the lid for the poles and a switch.
Have you done this and would you share your 3D-model with me?
Thanks and have a good time, cc
I remember reading here on this forum that some people 3d-printed cases for their DIY battery banks.
I'd like to pack my 4 280-Ah-cells and a BMS into such a box. Nothing fancy, just a simple box with 310 x 230 x 200 mm (L x W x H) INSIDE dimensions.
The lid could be fixed with screws, no need for a complicated hinge. I would drill holes through the lid for the poles and a switch.
Have you done this and would you share your 3D-model with me?
Thanks and have a good time, cc