SolarForU2
New Member
I'm looking for something to discharge Lifepo4 battery cells at a constant current down to a predefined cell cut-off voltage. I don't need to measure power out, just bring them down to a fixed value.
I have been using a CellPro PowerLab 8, for smaller batteries, but its pretty hopeless on these larger 400 AH battery cells and I have a lot to do.
Spec is discharge individually at 30-50 amps down to a set 2.9v, then taper off discharge current to approx an amp @2.9v; at that point cell is virtually fully discharged.
If anyone has seen something to do this, please post a link.
Cheers
Mike
I have been using a CellPro PowerLab 8, for smaller batteries, but its pretty hopeless on these larger 400 AH battery cells and I have a lot to do.
Spec is discharge individually at 30-50 amps down to a set 2.9v, then taper off discharge current to approx an amp @2.9v; at that point cell is virtually fully discharged.
If anyone has seen something to do this, please post a link.
Cheers
Mike