eXodus
Solar Addict
- Joined
- Jul 27, 2020
- Messages
- 1,482
I got a Gasoline Onan 5500w Generator in my RV which I want to control with my Growatt NC NO contact.
The Growatt switches when the battery voltages goes to low - and switches back when sufficient charged.
Means I got a high signal while it's calling for charge.
My Onan expects something differently.
Generator start:
Push the Prime Button until the light on the switch goes to green (can take anywhere from 2-30 seconds)
Release the Prime
Push the starter button until the generator starts (anywhere from 2-10 seconds)
Release the starter button.
(repeat if necessary once or twice)
To stop the generator
Press the Prime button (2 seconds)
Release the Prime button
Was unable to find a Autostart System which supports this behavior. Any ideas / leads before I get myself a Arduino and program one myself ?
The Growatt switches when the battery voltages goes to low - and switches back when sufficient charged.
Means I got a high signal while it's calling for charge.
My Onan expects something differently.
Generator start:
Push the Prime Button until the light on the switch goes to green (can take anywhere from 2-30 seconds)
Release the Prime
Push the starter button until the generator starts (anywhere from 2-10 seconds)
Release the starter button.
(repeat if necessary once or twice)
To stop the generator
Press the Prime button (2 seconds)
Release the Prime button
Was unable to find a Autostart System which supports this behavior. Any ideas / leads before I get myself a Arduino and program one myself ?