gyrex
New Member
Does anyone have any feedback on the Chargery BMS? I noticed that they have a new-ish product called the BMS16 v2.0 which appears to have integrated the LCD into the BMS itself. I'm interested in this BMS because of the seperate ports and the ability to wire the charge and discharge signal wires to my Victron MultiPlus II AUX inputs to control charging/discharging without the use of a relay/contactor.
I have read and seen YouTube videos of various issues with this BMS in the past, specifically relating to its inaccuracy with voltage and current (and by virtue SOC) measurements. Have these issues been fixed in newer firmware revisions and/or this new hardware? Does anyone have any recent experience with this BMS? Are you able to completely disable the BMS's balancing function? I saw in a youtube video that even with balancing disabled, the BMS was heating up likely due to balancing and resistor loads within the BMS.
I have read and seen YouTube videos of various issues with this BMS in the past, specifically relating to its inaccuracy with voltage and current (and by virtue SOC) measurements. Have these issues been fixed in newer firmware revisions and/or this new hardware? Does anyone have any recent experience with this BMS? Are you able to completely disable the BMS's balancing function? I saw in a youtube video that even with balancing disabled, the BMS was heating up likely due to balancing and resistor loads within the BMS.