dado
New Member
- Joined
- Dec 2, 2021
- Messages
- 5
Hi,
trying to connect the 100A Daly BMS (4S battery) to my Windows PC.
The BMS came with the Bluetooth module (with button) and works perfectly.
Now I want to connect to my PC to modify additional settings that are not available with the mobile app.
I ordered the UART-USB cable, which has a 6 pin connector (3 wires) and is plugged into the same port on the BMS as the Bluetooth module.
I installed the UART driver and the Sinowealth BMS tool on my PC.
When I open the BMS tool, the port connection is working, but I do not get any reading when scanning the parameters.
A message flickers in the status field, which reads something like "...not responding". It is displayed too short to read completely.
Btw, disconnecting the UART plug from the BMS does not change the behaviour. So apparently there is no communication happening at all.
To ensure that the BMS is activated, I plugged in the Bluetooth module again and pressed its button and verified that I can connect via app. Then I tested the UART connection again, but no change.
Any idea what could be wrong here?
Thanks
trying to connect the 100A Daly BMS (4S battery) to my Windows PC.
The BMS came with the Bluetooth module (with button) and works perfectly.
Now I want to connect to my PC to modify additional settings that are not available with the mobile app.
I ordered the UART-USB cable, which has a 6 pin connector (3 wires) and is plugged into the same port on the BMS as the Bluetooth module.
I installed the UART driver and the Sinowealth BMS tool on my PC.
When I open the BMS tool, the port connection is working, but I do not get any reading when scanning the parameters.
A message flickers in the status field, which reads something like "...not responding". It is displayed too short to read completely.
Btw, disconnecting the UART plug from the BMS does not change the behaviour. So apparently there is no communication happening at all.
To ensure that the BMS is activated, I plugged in the Bluetooth module again and pressed its button and verified that I can connect via app. Then I tested the UART connection again, but no change.
Any idea what could be wrong here?
Thanks